
How to clean a bathroom, tiles and grout step by step

By Urban Company
9 min read
Nov 15, 2026
The right order to clean an HDB bathroom, from ceiling to floor trap, how to get grey grout clean again, and which products never to mix.
It’s Saturday morning in a 4-room resale flat in Toa Payoh. The common toilet has a grey tide mark on the floor, grout that has gone from white to dull grey, and toothpaste on the mirror. The order you clean in matters more than what’s in the bottles, and most of the grime comes off with kitchen-cupboard basics.
Key takeaways
Clean from high to low and from clean to dirty: walls and shower first, then the mirror, sink and toilet, and the floor last.
Scrub the floor with a stiff deck brush, not a mop. Textured anti-slip tiles trap dirt that a mop slides over.
Grey grout is mostly soap scum, body oil and dirt. A baking soda paste and a stiff brush lift most of it.
Use 1 product at a time. Never mix bleach with vinegar, acidic toilet cleaner or ammonia, because the mix releases toxic gas.
Weekly/biweekly cleaning from Urban Company starts from $38 for 2 hours, and Bathroom Deep Cleaning starts from $65.
How do you clean a bathroom step by step?
Start at the top and finish at the floor trap, so every drip lands on a surface you haven’t cleaned yet.
NEA’s guidance for homes says to
clean from high to low, wall to floor, and from clean to dirty areas, such as from the shower to the toilet bowl. It also recommends letting fresh air in during and after cleaning.
Clear and ventilate. Take out mats, towels and toiletries, and open the window or switch on the fan.
Dust high. Wipe ceiling corners, the light cover and window louvres with a dry microfibre cloth.
Spray, then wait. Apply cleaner to the shower wall, sink and toilet bowl. A few minutes of contact time does most of the scrubbing.
Wall tiles and shower area. Wipe top to bottom with warm water and a little dishwashing liquid, then rinse.
Grout. Spread baking soda paste on the lines, wait 10 to 15 minutes, then scrub along each line with a stiff brush.
Mirror and glass. Wipe with a damp microfibre cloth and buff dry.
Sink and tap. Sponge the basin, brush around the tap base and overflow hole, rinse, and dry the chrome.
Toilet. With a separate cloth, wipe the cistern, flush handle, seat and hinges, then scrub the bowl and under the rim, and flush.
Floor last. Scrub with detergent and a deck brush towards the floor trap, rinse, and squeegee the water away.
Chalky marks on a shower screen or mirror need a different method: see
how to clean water stains on glass, mirrors and windows. Limescale on the shower head and stains in the toilet bowl are covered in
how to clean a shower head and a stained toilet bowl.
Why do bathroom tiles and grout get so dirty?
Soap, body oil and minerals in tap water dry onto the tiles after every shower, and grout soaks that film up.
Grout is cement-based and porous, so it holds what smooth glazed tiles shed. Most HDB bathrooms are fully wet, so the whole floor gets soaked, and a bathroom without a window or fan stays damp for hours.
Here’s what you’re usually looking at, and what shifts it:
What you see
What it usually is
What shifts it
Dull, filmy wall tiles
Soap scum
Detergent, then vinegar
Grey or brown grout
Soap, oil and dirt
Baking soda, stiff brush
Dark film by floor trap
Dirt where water pools
Detergent, deck brush
Orange rings on floor
Rust from cans
Diluted vinegar, rinse
Chalky marks on chrome
Limescale
Diluted vinegar soak
Black spots in silicone
Mould inside it
New silicone
For filmy soap scum on glazed tiles, spray a 1:1 mix of white vinegar and water, leave it 5 to 10 minutes, then rinse. For grout that stays grey after scrubbing, an oxygen bleach solution left for the time on its label usually lifts it. Test it on a small patch first if your grout is coloured.
What should you use on each part of the bathroom?
Mild detergent and a microfibre cloth handle most surfaces; acids and abrasives are for specific jobs only.
Surface
Use
Avoid
Wall and floor tiles
Mild detergent, brush
Toilet bowl cleaner
Grout lines
Baking soda paste
Wire brushes
Chrome taps, shower head
Mild soap; vinegar
Scouring pads
Sink basin
Dish soap, soft sponge
Abrasive powder
Toilet bowl
Toilet cleaner, brush
Mixing with bleach
Marble or stone
Mild detergent
Vinegar or acids
Timber door frame
Barely damp cloth
Splashing water
Keep toilet bowl cleaner inside the bowl. Many are strongly acidic, and on cement grout they wear the surface away so it stains faster. The timber door frame sits at the wet edge, and years of splashing leave its base swollen.
Which cleaning products should you never mix?
Never mix bleach with anything acidic or with ammonia.
Bleach plus vinegar or an acidic toilet cleaner releases chlorine gas; bleach plus ammonia releases chloramine. NEA’s
list of household disinfection productsalso tells households not to mix different disinfectant products and to use them in a well-ventilated area.
The risk is usually accidental: bleach on the floor, toilet cleaner in the bowl, both washing towards the same floor trap. Use 1 product per session, or rinse the first away completely with plain water before starting the second. Wear gloves and dilute exactly as the label says.
How often should you clean the bathroom in Singapore?
Squeegee daily, clean fully once a week, and deep clean once a month.
Singapore’s mean annual relative humidity is
around 82%, and it frequently reaches 100% during prolonged rain, so bathrooms here stay wet, and get dirty, faster than in drier countries.
Daily, 2 minutes: squeegee the walls and floor towards the floor trap, wipe the sink, open the window.
Weekly: the steps above.
Monthly: the deep-clean list below.
A dry floor is safer too. HealthHub notes that
most falls among older people happen at home, often because of hazards such as slippery floors, and suggests non-skid tape in the shower. For the rest of the flat, see
how often you should clean your home in Singapore.
How do you deep clean a bathroom?
Do the weekly clean, then add the jobs that build up slowly. Budget about an hour if the grout hasn’t been done in a while.
Grout: baking soda paste and a stiff brush along every line.
Shower head and taps: a diluted vinegar soak dissolves limescale.
Floor trap: lift the cover, pull out hair and soap scum, rinse and scrub the grating.
Behind the toilet base, the base of the walls, window louvres and the fan grille.
Pails: empty, scrub and store upside down so no water stands in them.
A second bathroom that nobody uses needs a look too. NEA’s dengue advice is to
cover rarely used gully traps, so water left in them can’t breed mosquitoes.
When is it not a cleaning problem?
When the bathroom is clean and something is still wrong, it’s a repair:
Slow drainage or water pooling at the floor trap is a choke, not dirt.
A sewer smell that comes back after cleaning usually starts in a dry or faulty floor trap.
Water pooling at the toilet base is a leak for a plumber.
Black spots that return in the silicone a week after cleaning mean the sealant needs replacing.
Cracked or missing grout can’t be cleaned back and needs regrouting, and cracked or hollow-sounding tiles need repair.
Everything else in this guide is a fair DIY job.
When is it worth getting a Professional?
There are two different jobs, and they need different help.
Keeping the bathroom clean week to week is part of a regular cleaning visit. Stripping back grout that stays grey or limescale that has built up over months is a deep clean. Here’s
how deep cleaning differs from regular cleaning.
If it’s the weekly clean that keeps slipping, Urban Company’s weekly/biweekly cleaning starts from $38 for 2 hours, with the same cleaner each visit. The cleaner brings the full cleaning kit, or uses your own products if you prefer, and prices include GST with no extra charge on weekends or public holidays.
See weekly/biweekly cleaning in Singapore.
If the grout stays grey after 2 or 3 proper scrubs, or you’re moving in or out, Urban Company’s Bathroom Deep Cleaning starts from $65 and is rated 4.71 from 1K reviews. It uses high-temperature steam disinfection, with deep scrubbing using heavy-duty tools to remove stains and buildup.
See Bathroom Deep Cleaning in Singapore.
Frequently asked questions
What is the right order to clean a bathroom?
Work from high to low and from clean to dirty. Clear the room, dust the ceiling corners and window louvres, then do the walls and shower area, the grout, the mirror, the sink and tap, the toilet, and the floor last, pushing water towards the floor trap. That way nothing dirty drips onto a finished surface.
How often should you clean the bathroom in Singapore?
Squeegee the floor and wipe the sink after each day’s showers, do a full clean once a week, and set aside time once a month for the grout, the shower head and the floor trap. A bathroom used by several people, or one without a window, usually needs the grout done more often.
How do you clean grout on floor tiles?
Spread a paste of baking soda and a little water along the grout lines, leave it for 10 to 15 minutes, then scrub along each line with a stiff grout brush or an old toothbrush. Rinse well. For grout that stays grey, an oxygen bleach solution left for the time on its label usually lifts it.
Should you mop a bathroom floor?
It’s better to scrub it. Most HDB bathrooms have textured anti-slip tiles, and their grooves hold dirt that a mop glides over. Scrub with detergent and a deck brush towards the floor trap, rinse, then squeegee the floor dry.
Can you use toilet bowl cleaner on bathroom tiles?
It’s better not to. Many toilet bowl cleaners are strongly acidic and made for glazed porcelain only. On cement grout they can wear the surface away and make it stain faster, and some contain bleach. Keep toilet bowl cleaner inside the bowl, and use a mild detergent or baking soda on tiles and grout.
Is vinegar safe for bathroom tiles?
Diluted white vinegar is fine on glazed ceramic and porcelain tiles for soap scum and water marks, if you rinse it off afterwards. Avoid it on marble and other natural stone, which acid can etch, and don’t use it on grout every week. Never mix vinegar with bleach.
Is it safe to clean the bathroom with bleach?
Yes, if it’s diluted exactly as the label says, the window is open and it’s the only product you use at that time. Never mix bleach with vinegar, acidic toilet cleaner or ammonia, as the combinations release toxic gas. Rinse it off completely before switching to another product, and wear gloves.
How do you clean a toilet properly?
Clean the toilet after the sink, not before, so the brush and cloth never go from bowl to basin. Put cleaner under the rim, let it sit while you wipe the cistern, handle, seat and hinges, then scrub the bowl and flush. Finish with the base and the floor around it, where splashes collect.













