
Why is my aircon not cooling? 6 common causes and fixes

By Urban Company
7 min read
Nov 15, 2026
The six usual reasons an aircon runs but won’t cool in Singapore, what you can fix yourself, and when to call a Professional.
An aircon that runs but doesn’t cool is usually one of six things: a clogged filter, a dirty evaporator coil, low refrigerant gas, a blocked outdoor condenser, a thermostat or sensor problem, or a failing compressor. The first one you can fix yourself today; the rest need a Professional. In Singapore, where
2025 brought the warmest June on record, a weak aircon is hard to live with for long.
Key takeaways
A clogged filter is the most common cause of an aircon not cooling, and NEA advises checking the filter once a month and cleaning it when needed.
Dirt on the back of the evaporator coil stops it absorbing heat; a filter wash doesn’t reach it, but a coil clean such as FoamJet servicing does.
Hissing sounds or ice on the coil or pipes point to low refrigerant gas, which needs a trained Professional to find the leak and top up.
If the aircon blows cold for a while and then switches to fan, check the remote settings before booking a repair.
Urban Company FoamJet servicing costs $20/unit for 3 or more units and $46 for 2 units; a repair starts with a $60 diagnosis visit (November 2026).
Why is my aircon not cooling?
Work through the causes below in order. They go from the easiest and most common to the rarest and most expensive. If the aircon won’t switch on at all, start with
our guide to an aircon that won’t turn oninstead.
1. Clogged air filters
This is the most common cause — and the easiest to fix. Your aircon’s filters trap dust, pet hair, and airborne particles over time. Once they’re clogged, airflow drops, your unit works harder, and cooling performance suffers noticeably.
Singapore’s humidity makes filters gather grime faster.
NEA adviseschecking the air filter once a month and cleaning or replacing it when necessary, so the unit runs efficiently.
What to do:
switch off the unit, lift the front panel, slide out the mesh filters and rinse them under the shower. Let them dry fully before putting them back. If the filters are clean and the room still won’t cool, the problem is further inside the unit. Our
step-by-step aircon filter guideshows how to rinse and dry the filters properly.
2. Dirty evaporator coils
The evaporator coil is what actually absorbs heat from the air in your room. When it gets coated in dust and grime — particularly on the back of the coil where most cleaning methods don’t reach — it loses the ability to absorb heat effectively. The result: your aircon runs but the air coming out isn’t cold.
A filter wash doesn’t reach the coil, and many services only wipe its front. Urban Company’s
FoamJet servicinguses high-pressure foam on the front and back of the evaporator coil, the filters, drain tray and blower wheel, then rinses it away. You’re shown the dirty water at the end.
What to do:
book a coil clean. FoamJet servicing is $20/unit for 3 or more units and $46 for 2 units on the booking page in November 2026.
3. Low refrigerant (gas)
Refrigerant is the substance that makes cooling possible — it absorbs heat from indoor air and releases it outside. If your unit has a refrigerant leak, cooling capacity drops significantly. You might notice the air feels slightly cool but never reaches the temperature you’ve set.
Signs your refrigerant may be low:
Air is less cold than it used to be, even on the lowest temperature setting
Hissing or bubbling sounds from the unit
Ice forming on the evaporator coil or copper pipes
What to do:
this needs a trained Professional, who checks for the leak and tops up the gas. Urban Company’s gas top-up starts at $49. Our guide to
what an aircon gas top-up costsexplains the R22, R410 and R32 prices and how to tell if gas is really the problem. If you can see ice on the coil, read
why an aircon freezes and what to dofirst.
4. Blocked condenser unit
The condenser is the outdoor unit, usually on the aircon ledge of an HDB flat or condo, or in the yard of a landed home. It releases the heat your indoor unit has absorbed. If dust coats its fins, or leaves and clutter block the airflow around it, the whole system cools less.
What to do:
keep the space around the condenser clear. Cleaning the fins needs a Professional; Urban Company’s condenser cleaning starts at $49.
5. Thermostat or sensor issues
Sometimes the problem isn’t the cooling system itself — it’s the thermostat misreading the room temperature and cutting the compressor too early. This can make it feel like the aircon isn’t cooling when it’s actually just stopping prematurely.
Check: is the aircon blowing cold air for a while and then switching to fan mode before the room feels cool? That pattern points to a thermostat or sensor issue rather than a coil or refrigerant problem.
What to do:
Check your remote settings first — make sure you’re on Cool mode, not Fan mode, and that the set temperature isn’t too high. If settings are correct and the issue persists, a Professional should inspect the sensor.
6. Compressor failure
The compressor is the heart of the system. It circulates the refrigerant and drives the whole cooling cycle. A failing compressor usually means no cooling at all — the unit may run and blow air, but nothing gets cold.
Compressor issues are typically the most expensive repair. They’re also often the result of years of inadequate maintenance — dirty coils and low refrigerant both put extra strain on the compressor over time.
What to do:
book a diagnosis. Urban Company charges a $60 visit fee for aircon repairs, which is replaced by the service cost if you go ahead with the fix.
How Urban Company fixes an aircon that isn’t cooling
FoamJet servicing, for dirty coils and weak airflow: $20/unit for 3 or more units; $46 for 2 units
Annual contract, FoamJet servicing twice a year: from $108
Condenser cleaning: from $49
Gas top-up: from $49
Chemical overhaul, for heavily clogged units: from $160, half gas top-up included
Repair for less cooling, leaks, power issues or noise: $60 diagnosis visit, replaced by the service cost if you go ahead
For a full breakdown of service types and costs, see our guide to
Aircon Servicing in Singapore. If the unit is also leaking, read
why your aircon is dripping water.
Why regular servicing prevents most of these problems
Clogged filters, dirty coils and a strained compressor are mostly preventable. Check and wash the filters monthly, as
NEA advises, and have a Professional service the coil regularly. Most homes that run the aircon daily book every 3 months. A regular coil clean costs far less than a chemical overhaul (from $160) or a compressor repair.
Frequently asked questions
Why is my aircon running but not cooling the room?
The most common reasons are dirty evaporator coils, clogged air filters, or low refrigerant. All 3 reduce your unit’s ability to absorb and remove heat from the room. A professional service will identify which one applies to your unit.
How do I know if my aircon needs gas top-up?
Signs include air that feels slightly cool but never reaches the set temperature, hissing sounds from the unit, or ice forming on the coil or pipes. A Professional can confirm with a pressure check.
How often should I clean my aircon filter in Singapore?
NEA advises checking the filter once a month and cleaning or replacing it when needed. Have a Professional service the coil every 3 to 6 months, or every 3 months if you run the aircon most of the day.
What is FoamJet Aircon Servicing?
FoamJet is Urban Company’s standard aircon service. High-pressure foam cleans the front and back of the evaporator coil, plus the filters, drain tray and blower wheel, and is rinsed away so you can see the dirty water that came out.
What’s the difference between Aircon Servicing and a chemical overhaul?
Servicing — done regularly — cleans the unit and maintains performance. A chemical overhaul is a more intensive process for units with heavy mould, rust, or blockage that regular servicing can’t clear. Regular FoamJet servicing is specifically designed to prevent the buildup that makes a chemical overhaul necessary.
How much does aircon repair cost in Singapore?
Urban Company charges a $60 visit fee to diagnose a repair, such as water leakage, weak cooling, power issues or noise. If you go ahead, the fee is replaced by the cost of the service.













